access point to help with radio wave communication, check that the SSID and password are correct, and then try
to make network settings again.
❏ Network status sheet
❏ Product status screen for Web Cong
Launch a web browser from the connected device, and then enter the IP address for Wi-Fi Direct (Simple AP) to
open Web Cong. Tap Product Status > Wi - Fi D i r e c t and check the Wi-Fi Direct status.
Disconnect unnecessary devices
If four devices have already been connected to the printer, disconnect the unnecessary devices and try to connect
the new device.
Delete the SSID for Wi-Fi Direct on the Wi-Fi screen for the device that you do not need to connect to the printer.
User's Guide
Solving Problems
110
To Next Page
Loading...
