Epson ET-2850 Series - Page 166

❏ Run a nozzle check to see if the print head nozzles are clogged.
If there are missing segments in the nozzle check pattern, the nozzles may be clogged. Repeat head cleaning and
the nozzle check alternately 3 times and check if the clogging has cleared.
Note that print head cleaning uses some ink.
“Checking and Cleaning the Print Head” on page 85
❏ Turn o the printer, wait for at least 12 hours, and then check if the clogging has cleared.
If the problem is clogging, leaving the printer for a while without printing may solve the problem.
You can check the following items while the printer is
o.
❏ Check that you are using genuine Epson ink bottles.
Try to use genuine Epson ink bottles. e use of non-genuine ink bottles may cause print quality to decline.
❏ Check if the translucent lm is smeared.
If there are smears on the translucent lm, carefully wipe o the smear.
“Cleaning the Translucent Film” on page 91
❏ Make sure that there are no paper fragments
le
inside the printer.
When you remove the paper, do not touch the translucent
lm
with your hand or the paper.
❏ Check the paper.
Check if the paper is curled or loaded with the printable side facing up.
“Paper Handling Precautions” on page 23
“Available Paper and Capacities” on page 188
“Unavailable Paper Types” on page 191
❏ If you turn o the printer, wait for at least 12 hours, and if print quality has still not improved, run Power
Cleaning.
“Running Power Cleaning” on page 87
If you cannot solve the problem by checking the solutions above, you may need to request repairs. Contact Epson
support.
Related Information
& “Cannot Solve Printing or Copying Problems” on page 165
& “Before Contacting Epson” on page 214
& “Contacting Epson Support” on page 214
Solving Problems > Cannot Solve Problem > Cannot Solve Printing or Copying Problems
166