4.
Slide the edge guides to the edges of the paper.
5.
Tilt the feeder guard until part (A) is not touching the paper.
c
Important:
❏ Do not place objects on the feeder guard. Doing so may prevent paper from feeding.
❏
e
feeder guard is designed to stop halfway to prevent paper feed problems. Tilt it until it stops.
6.
Select the paper size and paper type.
Note:
❏ For letterhead paper, select Letterhead as the paper type.
❏ For letterhead paper, if you print on paper that is smaller than the setting in the printer driver, the printer may print
beyond the edges of the paper which can lead to ink smears on your printouts and excess ink building up inside the
printer. Make sure you select the correct paper size setting.
❏ 2-sided printing and borderless printing are not available for letterhead paper. Also, the print speed may be slower.
Loading Paper
>
Loading Paper in the Rear Paper Feeder
26
To Next Page
Loading...
