Copyright © 2010 Seiko Epson Corporation. All rights reserved.
Printed in XXXXXX
To use the product, you have to enter the IDs that are indicated on each ink bottle when installing the software on your
computer. Conrm the IDs, and then install the software according to the instructions in the following section.
Note /
IDs consist of 13 alphanumeric characters except 0, O, 1, and I.
EN
Start Here
TH
1
Unpacking /
Remove all protective
materials.
Unhook.
A�
Open.
B�
Caution: Cautions must be observed to avoid damage to your equipment.
c
2
Filling Ink /
Do not pull the tubes.
c
For initial setup
For relling
Remove.
C�
D� E� F�
G� H� I�
Snap o, remove, and then install.
Match the ink color with the tank, and then ll with all of
the ink.
Install securely.
Seal the bottles. Do not dispose of the
ink bottles. The IDs that are indicated
on each ink bottle will be used later.
c
Hook onto.
Close.
Repeat steps C to F for each ink
bottle.
CF
J�
Connect and plug in.
Before printing, be sure to hook the ink tank unit onto the
product. Do not lay the ink tank unit down, or position the unit
higher or lower than the product.
c
Turn over /
Read This First /
This product requires careful handling of ink. Ink may splatter when the ink tanks are lled or relled with ink. If ink gets on your clothes or belongings, it may not
come o.
Do not open either of the two black ink bottles until you need to rell the ink
tank.
To Next Page
Need help?
General
