REV.-A
3.2.2 Removing the Printer Case
This section describes how to remove the front case and upper case.
3.2.2.1 Removing the Front Case
1. Remove the printer cover.
2. Use a screwdriver to release a clip and a screw that secure the front case to the upper case. Open
the front case. Disconnect connector CN
1
on the control panel board
(C060
PNL).
3. Remove the front case.
f“’”
Figure 3-4. Removing the Front Case
3.2.2.2 Removing the Upper Case
1. Remove the printer cover, the
2. Remove the two CBS(C)
(M3
X
cover.
paper tension unit, the tractor, and the paper advance knob.
12) screws that attach the optional interface card cover. Remove the
~.,.
‘k’-,,
CBS(C) (M3 x 12)
A
Screws
Cove;
for Optional
Interface Card
Figure 3-5. Removing the Optional Cover for Optional Interface Card
3. Remove the front case, as described in Section 3.2.2.1.
4. Remove the two
CBB(C)
(M4
X 14) screws that secure the upper case to the lower case.
5. Depress the two clips that hold the upper case to the front sheet
guide. Remove the upper case.
3-6
To Next Page
Loading...
