Epson LQ-1170 - Removing the Power Supply Board; Removing the Control Panel Board; C060 PNL Board

REV.-A
3.2.3.3 Removing the Power Supply Board (C060 PSB/PSE Board)
1.
2.
3.
4.
5.
Remove the upper case, as described in Section 3.2.2.2.
Remove the mechanism unit, as described in Section 3.2.4.
Disconnect the cable from connector
CN2 on the main board.
Disconnect the cable from connector
CN 1 on the power switch.
Remove the two
CBB(C) (M3 X 12) screws and the CBS(C)(M3 X 8) screws that attach the power supply
board to the lower case. Remove the power
CBB
(M3 X 12)
A
supply board.
C060 PSB/PSE
Board
CN2
CBS (ti3 X 8)
Figure 3-8. Removing the Power Supply Board
3.2.3.4 Removing the Control Panel Board
(C060 PNL Board)
1. Remove the front case, as described in Section 3.2.2.1.
2. Remove the 4
CBB(C) (M3 X 12) screws that secure the control panel board to the front case. Remove
the control panel board.
C060 PNL Board
Front, Case
CBB(C)(M3 X 1 O) Screws
g~;,
%,- ‘
Figure 3-9. Removing the Control Panel Board
3-8