Epson LQ-1170 - Removing the; Ffc

REV.-A
3.2.5.2 Removing the Paper Advance Motor
1. Remove the printer mechanism from the lower case, as described in Section 3.2.4.
2. Remove the retaining spring that holds the platen shaft.
3. Release the two clips holding the paper advance motor to the right frame.
4. Remove the paper advance motor from the right frame.
Advance Motor
Figure 3-12. Removing the Paper Advance Motor
Assembly Note
See Section 3.2.5.15 for details on arranging and positioning the motor cable.
3.2.5.3 Removing the
FFC
1. Remove the printhead, as described in Section 3.2.1.
2. Remove the printer mechanism from the lower case, as described in Section 3.2.4.
3. Remove the
FFC from the clips that hold it along the rear side of the printer mechanism. Make sure
that the
FFC is free.
4. Remove the
FFC from clip on the head cable holder at the rear of the printer mechanism.
5. Remove the clips that hold the head
cable holder to the base frame. Remove the FFC and the head
cable holder.
FFC
Figure 3-13. Removing the FFC Cable
Assembly Note
See Section 3.2.5.15 for details on arranging and positioning the
FFC.
3-11