Epson LQ-1170 - Platen

REV.-A
3.2.5.12 Removing the Front Paper-Out Detector
1
.
Remove the printer mechanism from the lower case, as described in Section 3.2.4.
2. open the clips that hold the front paper-out detector to the base frame. Remove the front paper-out
detector.
tor
Guide
Figure 3-25. Removing the Front Paper-out
Detector
3.2.5.13 Removing the Platen-Gap Sensor
1. Remove the printer mechanism from the lower case, as described in Section 3.2.4.
2. Remove the clips that hoId platen-gap sensor to the left frame. Remove the Platen-9aP sensor.
Adjust Lever
n \\ —-
Platen-gap Sensor
#- :.,,
T
c
f-:’
Figure 3-26. Removing the Platen-Gap Sensor
3-18