Epson LQ-2180 - Page 49

LQ-2180 Revision A
Appendix EEPROM Address Map 49
Table 7-5. EEPROM Address Map (5/7) Table 7-6. EEPROM Address Map (6/7)
Address Data Data Format
Q-pit
data
Factory
setting
29H Panel mask
pattern 1
b0: LOAD function
b1: EJECT function
b2: FONT selection
b3: PITCH selection
b4: TEAR OFF function
b5: BIN selection
b6: Draft self test
b7: LQ self test
00H 00H
2AH Panel mask
pattern 2
b0: LF function
b1: FF function
b2: Micro Adjust function
b3: Pause function
b4: Data dump
b5: Default setting
b6: Bi-d. adjustment
b7: (reserved)
00H 00H
2BH Manual insertion
wait time
3 to 30 (by 0.1 sec.), 00H: 2 sec
when Normal mode. (same as 3
sec when copy mode. default)
00H
(2or3 sec.)
00H
(2or3 sec.)
2CH Tear-off wait time 3 to 30 (by 0.1 sec.), 00H: 3 sec.
(the default)
00H
(3 sec.)
00H
(3 sec.)
2DH to
2EH
(reserved) 00H 00H
2FH Copy mode
0: Off 1: On
00H 00H
30H-33H Driving line count
for ribbon change
timing
0 - 0FFFFFFFFH (count) 000000
00H
000000
00H
34H-37H Driving Hour 0 - 0FFFFFFFFH (minutes) 000000
00H
000000
00H
38H-
3BH
Driving Line Count 0 - 0FFFFFFFFH (count) 000000
00H
000000
00H
Address Data Data Format
Q-pit
data
Factory
setting
3CH Starting Year 0 - 99 (the last two figures of
Anno Domini)
00H 00H
3DH Starting Month 1 - 12 00H 00H
3EH Starting Date 1 - 31 00H 00H
3FH Black paper mode
paper width
measure
b0: black paper mode
0: Off, 1: On
b1: paper width measure
0: On, 1: Off
b2: b2 to b7: (reserved)
00H 00H
40H to
41H
TOF Minimum
value
-120 to -60, 0: -60 (4.2 mm)
Value out of the range above is
considered -60.
00H 00H
42H I/F timing data bit0-3: BUSY timing data
bit4-7: XAACK timing data
00H 00H
43H
(complement of 42H)
FFH FFH
44H to
5DH
(reserved) 00H 00H
5EH,
5FH
Paper edge length 0000H 0000H
60H,
61H
Page length for
rear manual
insertion
1 to 22x360 (by 1/360 inch),
0000H: 22 inch (the default)
0000H
(22 inch)
0000H
(22 inch)
62H,
63H
Page length for
front manual
insertion
1 to 22x360 (by 1/360 inch),
0000H: 22 inch (the default)
0000H
(22 inch)
0000H
(22 inch)
64H to
66H
Sub-number for
customization
00H to 09H
000000H
(Standard)
000000H
(Standard)
67H (reserved)
00H 00H
http://www.4008109977.com guangzhou epson service :020-84207330