Epson LQ-300 + - Disassembly Procedures

HTTP://BBS.FIXCLUB.COM.CN
EPSON LQ-300+ Revision C
Disassembly and Assembly Disassembly and Assembly 56
4.2 Disassembly and Assembly
This section explains the disassembly and assembly of Product Name. Unless
otherwise specified, assembly can be done in the reverse order of the disassembly
procedure.
Anything that service person should pay attention to is described under “Check Point”.
Any adjustment required after assembly is described under “Adjustment”.
When you have to remove parts that are not described in this chapter, refer to the
exploded diagram on Appendix of this manual.
The figure below is the disassembly flowchart for main component.
Flowchart 4-1. Disassembly Flowchart (Main Component)
C A U T I O N

Read 4.1.1 "Precautions" before start disassembling the printer.

Remove ink ribbon and paper before disassembling the printer.
4.2.2 "Upper Housing
Removal"
4.2.1 "Printhead
Removal"
4.2.3 "Printer
Mechanism Removal"
4.2.4 "Board Assembly
and Panel Removal"
4.2.5 "C395 MAIN
Board Assembly
4.2.6 "C294PSB/PSE
Board Assembly
START