LWOO
Service
Manual
Product Description
1.2.1.1 Paper Handling Specifications
Paper paths
Cut sheet path:
Rear entry (manual insertion or optional
CSF)
Cannot handle multi-part paper using friction feed
Continuous paper paths:
Rear entry ( push tractor feed using the push tractor unit
or pull tractor feed using the pull tractor unit or push-pull
tractor feed using both tractor units)
Continuous paper parking:
Possible, using push tractor unit
CSF:
Cannot handle envelopes or multi-part paper
Feeding pitch:
%
~~,
1A
~ch,
or
Programmable feeding
in
increments of
$%o
inch, minimum
Feeding system:
Friction feed or
&actor
(push, pull, and push-pull) feed
❑
Friction feed
● Set the release lever to the friction position.
. Insert the left edge of the sheet at the marked position.
●
Do
not.perform
reverse feed in the area within 0.63 inch (16 mm) from the bottom edge of
the sheet.
Push tractorfeed
● Set the release lever to the tractor position.
●
Install the tractor unit in the rear in the push
&actor
position.
●
On the first page (that is, the page immediately after sheet loading) the accuracy of paper
feeding is not guaranteed within the area 0.87 inch (22 mm) from the top edge of the sheet.
●
On the last page, the accuracy of paper feeding is not guaranteed after the paper comes off
the tractor pins.
●
During printing
oflabels,
never perform reverse feeding.
●
Do
not eject the labels from the rear.
❑
Pull tractor feed
● Set the release lever to the tractor position.
. Install the tractor unit in the top in the pull tractor position.
● Do not perform reverse feeding.
● Do not eject them from the rear.
Push pull tractor feed
●
Set the release lever to the tractor position.
●
Install one tractor unit in the rear in the push tractor position and install the other tractor unit
in the top in the pull tractor position.
. Do not perform reverse feeding.
●
Do
not eject the paper from the rear.
Paper thickness
leve~
The adjust lever must be set to proper position for the
paper thickness, as shown below.
Table 1-2. Paper Thickness Lever Settings
Lever Position
Paper Thickness
Corresponding Paper
o
0.065 mm -0.12 mm (0.0026 in. -0.0047 in.)
Ordinary paper
1
0.12 mm -0.19 mm (0.0047 in. -0.0075 in.)
Multi-part forms (2 sheets)
2
0.19 mm -0.26 mm (0.0075 h. -0.01 in.)
Multi-part forms (3 sheets)
3
0.26 mm -0.32 mm (0.01 in. -0.013 in.)
Multi-part forms (4 sheets)
4
0.32 mm -0.44 mm (0.013 in. -0.017 in.)
Envelopes (20 lb.)
5
0.44 mm -0.52 mm (0.017 in. -0.02 in.)
Envelopes (24
lb.)
Paper-feeding speed:
See Table 1-3.
Rev. A
1-3
To Next Page
Loading...
