Epson LQ 300 - Printer Installation

Product Description LQ-300 Service Manual
1.4 OPERATING INSTRUCTIONS
This section describes control panel operation functions, self-test, hexadecimal dump, paper feed,
micro adjustment, and printer initialization methods.
1.4.1 Control Panel Operation
The printer control panel contains three non-lock-type push buttons and three LED indicators for
easy operation of the various printer functions.
Buttons
I.ight
Lights
A
Roman O 0
Py:li!: :
// ~1’[1
1’ $!!d
Font
&
/FF
Pause
Saris
Seriio ●
Courier* O
Draft O
W
Draft Condensad ● ● I 2
Paper
Parkd
h
I W ~ Micro Adjust
3sec
Figure 1-7. Control Panel
Buttons
Pause:
Font:
LFIFF:
Indicators
Pause (Orange):
Font 1 and 2 (Green):
Special Mode
Self-test mode:
Hex dump mode:
Default-setting mode:
Micro adjustment mode:
Paper park mode:
Switches printer status between printing and no printing, if there is
print data in the input buffer. When the printer is out of paper, the
light flashes and the beeper sounds three times.
S&c& one of the available fonts. When you hold down this button
while you turn on the printer, you enter the printer setting mode.
When you press this button, the printer feeds paper line by line.
Hold it down to load a single sheet, or to advance continuous paper
to next top-of-form position.
Lights when the printer in pause mode.
Indicates the currently selected font.
Hold down the LF/FF button and turn on the printer.
Hold down the
LF/FF and Font buttons and turn on the printer.
Hold down the
Font buttons and turn on the printer.
Hold down the
Pause button or Font button.
Hold down the Font and LF/FF buttons together.
1-16
Rev. A