Epson LQ 300 - Removing the CR Motor

LQ-300 Service Manual
Disassembly and Assembly
3.2.4.2
Removing the CR Motor
1.
Remove the printer mechanism (see Section 3.2.4).
2. Remove the extension spring from the hook on the CR motor and the hook on the base frame.
3. Remove the timing belt from the pulley drive.
4. Remove the E-ring, pulley washer, belt pulley flange, and pulley drive from the CR motor.
5. Rotate the CR motor counterclockwise and remove it.
Timing Belt
Extension Spring
Right Frame
Figure 3-10. Removing the CR Motor
Rev.A
3-11