LQ-300 Service Manual
Adjustments
11.
12.
13.
14.
15.
Press Y, then Enter. The default setting table appears on the display:
Uo.
Add Function
SW& Valid
1
language
English
2
Model
ID
STD
3
Character table
PC-437
4
Page length (Tractor)
11 inch
5
Skip-over-perforation
OFF
6
Auto tear-off
OFF
7 Graphic Print Direction
Uni-D
8
Software
ESC/P2
9
Auto line feed
OFF
10
Interface selection
Auto
Selection(l
0s)
11
Bit rate
19200 bps
12
Parity bit
None
13
Date Length
8 bit
14
ETWACK protocol
OFF
15
State Reply
OFF
16
Font
Roman
17
Model Name
LQ-300
These are the factory defaults programmed into this printer.
Press Y, then Enter to confirm these settings and return to the initial menu.
Exit the program by pressing 3, then Enter.
The following message appears on the display:
r
Any setting value specified within this program
is not stored in the
EEPROM
until
you turn the printer OFF.
Turn the printer OFF now.
Turn the printer off to store the defaults shown above into the
EEPROM
on the main board
assembly.
Notes:
1. If you have replaced the main board assembly, you must also perform the bidirectional
adjustment procedure after competing this procedure.
2. The
SOi7VVAREand
INTERFACE settings are not been able to change to Factory
setting by this program, but we
cm
only change those settings by operation panel.
Rev.A
4-3
To Next Page
Loading...
