Epson LQ-500 - Selecting the Multi-Font Module

The Multi-Font Module
4. Replace the compartment cover.
Selecting the Multi-Font Module
You can select the Multi-Font Module by using the SelecType panel
or by setting two DIP switches located inside the font
compartment.
To select the font using SelecType:
1. Turn on the printer and set it on line.
2. Press the FORM FEED button until both SelecType lights are on.
This selects the Multi-Font Module.
When you select a font using SelecType, it remains in use until the
printer is turned off, reset, or initialized.
Appendix
A-17