REV.-A
GENERAL DESCRIPTION 1
1.1 FEATURES
The LQ-510 is a small, light-weight, low-cost printer, comparable to the LQ-500 with advanced paper-handling.
Its main features are as follows:
1. Advanced paper handling: auto back-out and cut-sheet loading.
2.
Expanded ESC/P-code printing, implemented as a standard feature.
3.
Printing speeds in characters per second (cps):
180 cps (alphanumeric Draft 12 cpi)
150 cps (alphanumeric Draft 10 cpi)
60 cps (alphanumeric LQ 12 cpi)
50 cps (alphanumeric LQ 10 cpi)
4. Optional 8100 series interface.
5.
Clear, easy-to-read printing with a standard Epson font.
6. Two built-in LQ fonts (Roman and Sans Serif).
7.
An optional multi-font module can provide a wide variety of fonts.
8.
Control panel switch selection of Draft, Roman, Sans Serif, or slot-mounted (optional multi-font module)
font.
9.
Control panel switch selection of normal or condensed printing.
10. Optional cut-sheet feeder (CSF) for easy handling of cut sheets.
The LQ-510 is equipped with the standard Epson 8-bit parallel interface. Various interface options allow prin-
ting from a wide variety of computers, Table l-l lists the interface options, Table 1-2 lists the optional units
available, and Figure l-l shows an exterior view of the printer.
Table l-l. Interface Options
Intelligent serial interface board
Intelligent IEEE-488 interface board
NOTE:
Refer to the “Optional Interface Technical Manual” for details.
Table 1-2. Optional Units
Model
Description
C80612
Single-bin cut-sheet feeder
C80006
Pull tractor unit
7753
Ribbon cartridge (black)
7768
Film ribbon cartridge
7407
Multi-font cartridge
LQ-510
1-1
To Next Page
Loading...
