Epson LQ-510 - Operating Principles of the Cut-Sheet Feeder

REV.-A
OPTIONAL EQUIPMENT
3.3.2 OPERATING PRINCIPLES OF THE CUT-SHEET FEEDER
The cut-sheet feeder is driven by firmware incorporated in the printer. The feeder need not be electronically
connected to the printer. Cut-sheet feeder mode can be selected either by DIP switch or by command.
Selection by DIP Switch
The cut-sheet mode is set by DIP switch as shown in the table below.
Table 3-6. DIP Switch Selection
DIP Switch Function
1-8 Cut-Sheet Feeder Mode
ON
Valid
OFF
Invalid
Selection by Command
After the cut-sheet feeder has been mounted on the printer, the following command can be used.
Command:
Format:
ESC EM
CHR$(27); CHR$(25); “n”
where “n” signifies the following:
n=0
cancels the CSF mode
n =4
specifies the CSF mode
n=R
ejects a sheet
NOTE: This command should be input when paper is loaded.
LQ-510 3-9