REV.-A
OPTIONAL EQUIPMENT
3.3.3 CUT-SHEET FEEDER DISASSEMBLY AND REASSEMBLY
This section describes the procedure for removing the hopper unit of the C80612 cut-sheet feeder. Unless
otherwise specified, reassembly is performed by reversing the sequence. The diagrams in Figure A-34, which
are provided as reference for disassembly and reassembly, show an exploded view of the parts configuration.
The required tools are listed in Table 3-7.
Table 3-7. Tools for Assembly or Disassembly
Tool
Availability Part No.
Phillips screwdriver no. 2
0
8743800200
E-ring holder #6
I
0
1
8740800800
o: commercially available
WARNING
If it is necessary to replace one of the paper-loading rollers, both right and left rollers must be replaced
at the same
time.
LQ-510
3-11
To Next Page
Loading...
