Epson LQ-510 - Page 127

OPTIONAL EQUIPMENT REV.-A
3.4.2 PULL TRACTOR DISASSEMBLY AND REASSEMBLY
1. Remove the catch fastening the sprocket reduction gear to sprocket mounting plate R. Then remove
the reduction gear.
2. From the sprocket shaft, remove the E-ring (6), the sprocket gear, the sprocket gear spring, and the washer.
3. Remove the E-ring (6) on the inside of mounting plate R.
Mounting
Plate R
Washer
cket Gear Spring
Gear and Related Parts
shaft from mounting plate L.
Sprocket Reduction
Gear
Figure 3-14. Removal of Sprocket Reduction
4. Pull to remove the sprocket shaft and the sprocket support
-
Mounting Plate L
Sprocket Support Shaft
Figure 3-15. Removal of Sprocket Mounting Plate L
3-18
LQ-510