Epson LQ-510 - Table 1-3. Cut-Sheet Specifications; Table 1-4. Continuous Paper Specifications

GENERAL DESCRIPTION
REV.-A
Push Tractor Feed
1. Use the pull-out unit.
2. Do not perform reverse feeding for distances greater than 1/6 inch.
3. Accuracy of paper feed cannot be assured, and reverse feeding cannot be performed, after the paper
end is detected.
Push-Pull Feed
1. Remove the pull-out unit and attach the pull tractor unit.
2. Do not lose the paper between the platen and pull tractor unit.
3. Precisely adjust the horizontal positions of the pull and the push tractors.
4. Do not perform reverse feeding for distances greater than 1/6 inch.
5. Do not perform reverse feeding after the paper end is detected.
Pull Tractor Feed
1. Remove the pull-out unit and attach the pull tractor unit.
Line Spacing
Paper Insertion
Paper-Feed Speed
Paper Specifications
1/6 inch, or programmable in units of 1/360 inch
From rear
Friction, without CSF
100 ms/line (at 1/6-inch line feed)
2.2 inches per second (continuous feed)
Friction, with CSF
100 ms/line (at 1/6-inch line feed)
2.2 inches per second (continuous feed)
Tractor
100 ms/line (at 1/6-inch line feed)
2.2 inches per second (continuous feed)
See Tables 1-3 through 1-6.
Table 1-3. Cut-Sheet Specifications
Width
Length
Thickness
Weight
Quality
Copies
7.15 to 10.1 inches (182 to 257 mm)
14.3 inches, maximum (364 mm, maximum)
0.0025 to 0.0055 inch (0.065 to 0.14 mm)
14 to 24 pounds (52.3 g/m
2
to 90 g/m
2
)
Xerographic, bond, airmail paper, etc.
Not available
Table 1-4. Continuous-Paper Specifications
Width
Copies
Quality
Total Thickness
Weight
4 to 10 inches (101 to 254 mm)
3 sheets (1 original and 2 copies)
Bond, xerographic, airmail, etc.
0.0025 to 0.01 inch (0.065 to 0.25 mm)
1 sheet - 14 to 22 pounds (52.3 g/m
2
to 82 g/m
2
)
3 sheets - 12 to 15 pounds (40 g/m
2
to 58.2 g/m
2
) each
1-4
LQ-510