DISASSEMBLY, ASSEMBLY, AND ADJUSTMENT
REV.-A
3.
Insert a standard screwdriver into each of the two holes at the front of the lower case, and gently push
(see Figure 4-5) to unlock the notches.
(see Figure 4-5) to unlock the notches.
Upper Case Guide
Upper Case Guide
The
notch can be unlocked by
pushing it in the direction shown by
the arrow using the screwdriver.
Figure 4-5. Upper Case Removal - 1Figure 4-5. Upper Case Removal - 1
Lower Case
NotchNotch
4.
While lifting the upper case, disconnect the cable of the control panel (SANPNL) from connector CN4
on the SAMA board. Then remove the upper case.
Figure 4-6. Upper Case Removal - 2
4-6
LQ-510
To Next Page
Loading...
