Epson LQ-510 - Removal of Circuit Boards; SAMA Board Removal

DISASSEMBLY, ASSEMBLY, AND ADJUSTMENT
REV.-A
4.2.3 REMOVAL OF CIRCUIT BOARDS
This section describes the procedure for removing the SAMA board and the SANPS(E) board.
4.2.3.1 SAMA Board Removal
1. Remove the upper case (refer to Section 4.2.2.1). The following connectors on the SAMA board, connec-
ting it to external components, should be disconnected: CN5 (red), CN6 (yellow), CN7 (white), CN8 (flexible
flat cable, or “FFC”), CN9 (FFC), CN13 (black), CN12 (white), CN11 (white), and CN10 (white).
Do not pull roughly on the connectors or you may damage the board Remove them by pulling gently
while holding the board at the same time.
m CN12
.
CBB(C) (M3x8) Screw
SAMA Board
\
CN10
CN11
CBS(C) (M3x8) Screw
Figure 4-8. SAMA Board Removal
4-6
LQ-510