DISASSEMBLY, ASSEMBLY, AND ADJUSTMENT
REV.-A
4.2.5.5 Removal of Carriage Unit
1.
2.
3.
4.
5.
Remove the printer mechanism (refer to Section 4.2.4).
Remove the printhead and disconnect the head cable.
Turn the printer mechanism upside down, and manually move the carriage unit until it is at the cut-out
section of the carriage motor frame, The joint of the carriage unit and timing belt should be visible through
the cut-out.
Figure 4-26. Bottom View of Printer Mechanism
Using round-nose pliers, detach the timing belt from the carriage unit. Be careful not to cause any damage.
Lift portion A (see Figure 4-27) of the carriage guide shaft ground plate to free the plate from the notch
on the carriage motor frame. Slide the plate so that it can be removed from the frame (through the cut-
out at portion B of the plate).
Carriage Guide
/B
Carriage Motor Frame
Carriage Guide
Shaft Ground Plate
Figure 4-27. Removal of Carriage Guide Shaft Ground Plate
4-20
LQ-510
To Next Page
Loading...
