Epson LQ-510 - Removal of Carriage Motor

REV.-A
DISASSEMBLY, ASSEMBLY, AND ADJUSTMENT
4.2.5.6 Removal of Carriage Motor
1. Perform steps 1 to 5 of Section 4.2.5.4.
2. Disconnect the motor cable from the carriage motor. Disconnect the lead wire of the home-position sen-
sor from the molded clip at the bottom of the frame. (Refer to Figure 4-31.)
3. With a screwdriver, loosen the four tabs securing the carriage motor frame to the chassis frame. Remove
the carriage motor frame.
Tabs
Figure 4-31. Carriage Motor Frame Removal
4. Remove the belt tension spring from the carriage motor frame. Remove the E-type (3.2) retaining ring
on the carriage motor side; then remove the plain washer, belt pulley shaft holder, belt pulley, and timing
belt.
Retaining E-Ring (3.2)
Plain Washer
i!!G
Bait Pulley Flange
w
Belt Pulley Shaft Holder
Carriage Motor Frame
Belt Tension
Spring
Figure 4-32. Removal of Carriage Motor
5. Remove the carriage motor by moving it in the direction shown by the arrow above.
LQ-510
4-23