MAINTENANCE
REV.-A
Table 6-2. Lubrication Points (Refer to Figure 6-3)
Ref. No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
Lubrication Points
Shaft that holds paper-feed reduction
Contact portion of sub paper release lever and paper release lever
Oil pad
Carriage guide shaft (at both left and right sides of carriage)
Carriage guide plate (the portion that contacts the carriage)
Platen gear
Belt pulley gear
Ribbon transmission gear
Paper-tension roller shaft
Gear portion of the ribbon gear
Shaft that holds the ribbon gears
Paper-feed roller shaft
Contact portion of tractor frame L and tractor shaft .
GND spring on platen shaft
Lubricant
G-26
G-26
O-2
G-26
G-26
G-26
G-26
G-26
G-26
G-26
G-26
G-37
G-26
G-20
NOTE: Lubrication is necessary in the process of assembly.
Table 6-3. Adhesive Application Point (Refer to Figure 6-1)
Adhesive Application Point
No. of Points
Where the timing belt engages the carriage.
I
1
I
To Timing Belt
Figure 6-1. Correct Adhesive Application
PF Motor
Plate
Figure 6-2. GND Spring Lubrication Point
6-2
LQ-510
To Next Page
Loading...
