Epson LQ-510 - Table 1-8. Character Matrix and Character Size

REV.-A
GENERAL DESCRIPTION
Table 1-8. Character Matrix and Character Size
Printing mode
I
Face matrix HDD
I
Character size
H x V (mm)
Draft 10-pitch
I
9 x 23
I
120
I
1.9 x 3.2
Draft 12-pitch 9 x 23 120 1.9 x 3.2
Draft 15-pitch 9 X 16 120 1.0 x 2.3
Draft 10-pitch, condensed - 240 -
Draft 12-pitch. condensed - 240 -
LQ 10-pitch
I
29 x 23
I
360
I
2.0 x 3.2
180
LQ 12-pitch
I
29 x 23
I
360
I
2.0 x 3.2 180
LQ 15-pitch
I
15 x 16
I
360
I
1.0 x 2.3 180
LQ 10-pitch, condensed - 360 -
LQ 12-pitch, condensed - 360 -
LQ proportional 37 x 23 maximum 360 2.6 x 3.2
18 x 23 minimum 360 1.O x 3.2
LQ proportional, condensed
LQ proportional, super/ 28 x 16 maximum 360 1.8 x 2.3
subscript 12 x 16 minimum 360 0.7 x 2.3
LQ proportional, super/ - 360 -
subscript, condensed - 360 -
Unit ESC sp
120
120
120
240
360
180
180
360
360
180
180
360
360
NOTES: 1. HDD is horizontal dot density in dots per inch.
2. Face matrix and character size indicate maximum character size. This value changes accord-
ing to differences in paper, ribbon, etc.
3. Unit ESC sp (which also can be sent as the unit followed by the character string CHR$(&h20))
indicates the minimum length to be added to the right of the character that can be specified
with the ESC sp control code.
4. “_”
indicates that character matrix is reshaped by printer firmware. Character width becomes
half of noncondensed character width.
LQ-510
1-11