GENERAL DESCRIPTION
Table 1-14. Font Select&n
(ROM Version SD6-W6 or Below
or TAA04C or Below)
Tab& 1-14. Page Length Selection
(ROM Version TBD00A or Above
or TBC00A or Above
Table 1-15. Character Pitch Selection
Character Pitch
2-7
2-6 (ln characters per inch)
1.4.2 JUMPER SETTING
Jumper 10, which is user-selectable, is located inside the option board cover. If the jumper is connected,
the SLCT-IN signal is fixed to LOW, and DC1 /DC3 printer select control is ignored.
1.5 SELECTYPE FUNCTION
SelecType
enables easy selection of fonts and
printing modes, and can be used to select any of the
fonts listed on the control panel for either condensed or normal printing.
If the printer uses an
optional slot-mounted multi-font (ROM cartridge), these fonts also can be selected from the control
panel. SelecType functions only when the printer is not printing, at which time the font can be
selected
by pressing the FONT switch.
The printing
mode is selected by pressing the CONDENSED
switch (again,
only when the printer is not printing).
The selected font and mode are indicated on the
printer’s control panel.
LQ-510
1-17
To Next Page
Loading...
