Printing on Special Paper
4.
Reattach the printer cover as shown below.
To help you check the position of the paper thickness lever, the
orange MULTI-PART light on the control panel comes on if the
lever is set to position 4 or higher.
WARNING: Always return the lever to position 2 when
you go back to printing on ordinary paper. Continuous
printing with the lever set at a position higher than 2 can
shorten the life of the print head. Printing past the edge of
envelopes, multi-part forms, labels, or thicker-than-
normal paper can damage the print head.
Multi-part Forms
With the built-in tractor unit, your printer can print on continuous
multi-part forms. You can use multi-part forms that have up to three
parts including the original. Make sure you set the paper thickness
lever to the proper position; see the table on page 2-22.
Paper Handling
2-23
To Next Page
Loading...
