Testing the Printer
CAUTION: Run the self test using paper at least 210 mm
(8.2 inches) wide for the LQ-570 or 360 mm (14 inches)
wide for the LQ-1070; otherwise, the print head prints
directly on the platen.
4. Insert a sheet of paper between the edge guides until it meets
resistance. After a few seconds, the printer loads the paper to
the loading position and begins printing the self test.
5. To stop the self test, press the PAUSE button (you can resume
the self test by pressing the PAUSE button again).
6. Press the LOAD/EJECT button to eject the paper from the printer
and then turn the printer off.
Note: If test results are not satisfactory, see Chapter 6.
I
Here is part of a typical self test.
Roman
1-12
Setting Up the Printer
To Next Page
Loading...
