Cut-Sheet Feeders
3. Make sure the paper-release lever is in the single-sheet position.
4. Hold the cut-sheet feeder in both hands and press back on the
latch levers on each side. Fit the notches in the cut-sheet feeder
over the mounting posts on the printer. Release the latch levers
and lower the cut-sheet feeder until it rests on the printer.
You are now ready to load paper with your cut-sheet feeder.
Removing a cut-sheet feeder is the reverse of the steps above.
Loading paper with the single-bin cut-sheet feeder
Load paper using the single-bin cut-sheet feeder as follows:
1. Turn off the printer. Remove the paper guide, if necessary.
Using Printer Options
4-3
To Next Page
Loading...
