Epson LQ-570e - Page 116

EPSON LQ-570e/LQ-580 Revision C
Appendix EEPROM Address Map
1
16
56H *ACK timing data
b0-b2: *ACK/*BUSY width *ACK/ *BUSY width
0 2/2+3 2/1+3
1 4/4+3 4/2+3
2 6/6+3 6/3+3
3 8/8+3 8/4+3
4 10/10+3 10/5+3
5 20/20+3 20/10+3
6 40/40+3 40/20+3
7 80/80+3 80/40+3
(by 1/10 second)
b3-b6: (reserved)
b7 0:IEEE1284 1:EPSON Traditional
00H 01H
57H *ACK timing data(complement of 56H) 00H FEH
58H,59H (reserved) 0000H 0000H
5AH,5BH TOF Minimum value
-120 to -60, 0 : -60(4.2mm)
In case that it is big than -60, a value considers as -60.
0000H 0000H
5CH Copy mode
b0:copy mode 0:Off 1:On
b1-b7: (reserved)
00H 00H
5DH Energy save mode
b0:Energy save mode 0:On 1:Off
b1-b7: (reserved)
00H 00H
5EH,5FH Paper edge length 0000H 0000H
60H,61H Page length for rear manual insertion
1 to 22x360 by 0.0706mm(1/360 inch),
0000H : 558.8mm(22 inch: same as default)
0000H 0000H
62H,63H Page length for front manual insertion
1 to 22Å~360 by 0.0706mm(1/360 inch),
0000H : 558.8mm(22 inch: same as default)
0000H 0000H
64H-67H (reserved) 00H 00H
Area 2
68H-6AH Sub-numberfor customization 00H to 09H 000000H(Standard) 000000H(Standard)
6BH Market ID 0:LQ-580 1:LQ-570e 00H 00H
6CH Market CG 0:Standard version 1:NLSP version 00H 00H
Table 7-15. EEPROM Address Map
Address Data Data Format Q-pit data Factory Setting