Epson LQ-570e - Page 43

EPSON LQ-570e/LQ-580 Revision C
Product Description
C
ontrol codes
4
3
o test_print_code
o Paper_path
o characteristic status code
o MIB proxy information
“1G:”
“030FNA,” Sheet feeder bin (removable), capacity 15mm,
quantity of paper N.A.
“0505NA,” Sheet feeder bin 2 (removable), capacity 5mm,
quantity of paper N.A.
“08NANA,” Manual feed front, capacity N.A., quantity of paper N.A
“09NANA,” Manual feed rear, capacity N.A., quantity of paper N.A.
“0CNANA;” Tractor rear, capacity N.A., quantity of paper N.A.
“TEC:07;” 24pin SIDM
o Packet commands
(*1) The reply string is as same as BDC-ID Reply.
(*2) The reply string is as same as BDC-ST Reply.
Error “<error code>”
Fatal error “00”
Port is not selected “01”
Release lever position error “03”
Paper out “06”
Self printing “<self print code>”
Test printing “00”
Setting printing “02”
paper_path “<paper_path code>”
Continuous paper (rear) “0000”
Cut sheet (rear) “0200”
Cut sheet (front) “0201”
CSF bin1 “0100”
CSF bin2 “0101”
location size type Refer to
Structure version +0 2bytes “02” fixed -
Starting date +2 6bytes “yy”, “mm, “dd” “SD” command
Total printing line number +8 8bytes “nnnnnnnn” “TL” command
Total power on hour +16 4bytes “nnnn” “TL” command
Total printing number for
ribbon charge timing
+20 8bytes “nnnnnnnn” “TL” command
Table 1-36. Packet Commands
Function Code
Device ID request “di” 01H 00H 01H
Device ID reply (*1) “@EJL” SP “ID” CR LF <Device ID string> FF
State-Reply request “st” 01H 00H 01H
State-Reply (*2) “@BDC” SP “ST” CR LF <printer status string> FF
No support command
“XX
:;” FF
(XX is the command string being invalid.)