Epson LQ-570e - Page 90

EPSON LQ-570e/LQ-580 Revision C
Disassembly and Assembly Disassembly and Assembly
8
9
Figure 4-26. Mounting the Carriage Assembly
When attaching the timing belt to the carriage assembly, secure the
timing belt using the left and light clips of the carriage assembly as
shown below.
Figure 4-25. Attaching the Timing Belt
When mounting the carriage assembly and guide CR shaft;
n Check the direction of the guide CR shaft during insertion.
n Check the CR assembly smoothly slide down when the shaft is
put vertical.
n Check the big hole of the guide CR shaft faces up.
n Insert the tab of the CR assembly into the cutout section and
slide CR assembly to the left side of the mechanism.
(See the Figure 4-26, "Mounting the Carriage Assembly")
Clip
NG
OK
T
IM IN G B E L T
ADJUSTM ENT
REQUIRED
After removing the carriage assembly, perform the Platen Gap
adjustment and Bi-d adjustment.