Safety Instructions 5
1
1
1
1
1
1
1
1
1
1
1
1
❏ Do not load continuous paper with labels from the rear paper
slot. Because the paper path from the rear slot is curved, labels
may come off their backing sheets inside the printer and cause
a paper jam.
❏ Do not load paper that is curled or has been folded.
When operating the printer
❏ Adjust only those controls that are covered in the user
documentation. Improper adjustment of other controls may
result in damage requiring extensive repair by a qualified
technician.
❏ Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise, you may damage the
printer.
❏ Do not turn off the printer while it is printing the self test.
Always press the Pause button to stop printing and the
Load/Eject button to eject the printed page before you turn
off the printer.
❏ Do not turn off the printer while it is printing the hex dump.
Always press the Pause button to stop printing and the
Load/Eject button to eject the printed page before you turn
off the printer.
❏ Do not reconnect the power cord to an electrical outlet that
has the wrong voltage for your printer.
❏ Never replace the print head yourself; you may damage the
printer. Also, other parts of the printer must be checked when
the print head is replaced.
❏ You need to move the print head by hand to replace the ribbon
cartridge. If you have just used the printer, the print head may
be hot; let it cool for a few minutes before touching it.
To Next Page
Loading...
