124 Control Panel
Changing default settings
The following table shows the basic function of each button in the
default setting mode.
Follow these steps to enter the default-setting mode and change
the printer’s default settings:
Note:
❏ Before entering the default-setting mode, you need to load A4 or
letter size single-sheet paper or continuous paper that is at least 210
mm (8.3 inches) wide. See “Loading Continuous Paper” on page 14
and “Loading Single Sheets” on page 48 for instructions on loading
continuous paper and single sheets.
❏ If you use single sheets, you need to load a new sheet of paper each
time the printer ejects a printed sheet from the paper guide.
❏ For your safety, Epson recommends operating the printer with the
printer cover closed. The printer will function with the printer cover
open or removed, but for maximum safety keep the cover closed.
❏ If you turn off the printer prior to exiting default-setting mode, any
changes you may have made are canceled and not saved.
1. Make sure paper is loaded.
2. Press the Menu (Pitch and Tear Off/Bin) buttons until the
printer beep once and the Menu lights (both the Tear Off/Bin
lights) turn on.
Button Basic function
Menu (Pitch and Tear
Off/Bin) buttons
Enters or exits the default setting mode.
ItemD button Selects the next menu parameter.
ItemU button Selects the previous menu parameter.
Set button Changes the value in the selected menu.
To Next Page
Loading...
