24 Paper Handling
This section provides instructions on “Installing the tractor in the
rear push position” on page 24, “Loading paper with the rear
push tractor” on page 25, and “Removing the tractor from the rear
push position” on page 29.
Note:
Thick paper, such as continuous paper with labels or multipart forms
with five parts, requires a relatively straight paper path to avoid paper
jams. When printing on thick continuous paper, use the tractor in the
front push position or the pull position.
Installing the tractor in the rear push position
Before installing the tractor in the rear push position, remove it
from its current position. If the tractor is in the front push position,
remove it by pressing the tractor’s lock tabs while lifting it out. If
the tractor is in the pull position, remove it as described in
“Removing the tractor from the pull position” on page 40.
1. Make sure the printer is turned off. Then open the paper guide
cover by pulling its back edge forward.
2. Lift the paper guide up and off the printer.
To Next Page
Loading...
