62 Paper Handling
Follow these steps to adjust the tear-off position:
c
Caution:
Never use the knob to adjust the tear-off position; this may damage
the printer or cause it to lose the tear-off position.
Note:
Your tear-off position setting remains in effect until you change it, even
if you turn off the printer.
1. Make sure the Tear Off/Bin light is flashing (the paper is at
the current tear-off position). You may need to press the Tear
Off/Bin button to advance the paper to the tear-off position.
2. Hold down the Pause button for about three seconds. The
Pause light begins flashing and the printer enters the Micro
Adjust mode.
To Next Page
Loading...
