Paper Handling 21
1
1
1
1
1
1
1
1
1
1
1
1
4. Hold down the Pause button for about three seconds. The
Pause light starts flashing and the printer enters the Micro
Adjust mode.
5. Press the LF/FF D button to move the top-of-form position
down on the page, or press the Load/Eject U button to move
the top-of-form position up on the page.
Note:
❏ The printer has a minimum and a maximum top-of-form
position. If you try to adjust it beyond these limits, the printer
beeps and stops moving the paper.
❏ When the paper reaches the default top-of-form position, the
printer also beeps and stops moving the paper briefly. You can
use the default setting as a reference point when adjusting the
top-of-form position.
6. After you set the top-of-form position, press the Pause button
to exit the Micro Adjust mode.
To Next Page
Loading...
