Epson LQ-690II - Printer Default Settings; Overview of Default Printer Settings

Roman Script
Sans Serif Others
= on, = off, = flashing
3. Press the button to apply the setting and exit the font select mode.
About Your Printer’s Default Settings
The default settings control many printer functions. While you can often set these functions
through your software or printer driver, you may sometimes need to change a default setting from
the printer’s control panel using the Default Setting mode.
Default Setting mode
The following table lists the default settings and the options you can select in the Default Setting
mode. The settings are explained in detail after the table. For instructions on changing the default
settings, see “Changing default settings” on page 26.
Item Setting / value *1
Page length for tractor 3inch, 3.5inch, 4inch, 5.5inch, 6inch, 7inch, 8inch, 8.5inch, 11inch,
70/6inch, 12inch, 14inch, 17inch
Skip over perforation Off, On
Auto tear off Off, On
Auto tear off wait time 0.5 seconds, 3 seconds
Auto line feed Off, On
Print direction Bi-D, Uni-D, Auto
Software ESC/P2, IBM PPDS
0 slash Off (0),
I/F mode
Auto, Parallel, USB, Network*
3
Auto I/F wait time 10 seconds, 30 seconds
Parallel I/F bidirectional mode Off, On
LQ-690II/LQ-690IIN User’s Guide
Printer Basics 21