You can select the printer functions to be locked while the lock-out mode is on according to your
needs.
Note:
Before entering the lock-out setting mode, you need to load A4 or letter size single-sheet paper or
continuous paper that is at least 210 mm (8.3 inches) wide. See “Loading Continuous Paper” on
page 33 and “Loading Single Sheets” on page 39 for instructions on loading continuous paper and
single sheets.
Follow these steps to change the lock-out mode setting:
1. Make sure the printer is turned off.
!
Caution:
Whenever you turn off the printer, wait at least five seconds before turning it back on;
otherwise, you may damage the printer.
2. Turn on the printer while holding down both the d and
buttons.
The printer enters the lock-out setting mode and prints a message asking if you wish to print all
of the current settings.
3. If you want to print the current settings, press the o button. If you want to bypass printing of
the current settings, press the d button or the u button.
The printer prints the first menu and the current value of the menu.
4. Press the d button or the u button to select the menu parameters which you wish to change.
Press the o button to scroll through the values within the selected parameter until you find the
desired setting. After setting the selected parameter to the desired setting, you may continue to
make changes to other parameters by pressing the d button or the u button.
5. Turn off the printer and exit the lock-out setting mode.
Note:
You may exit the lock-out setting mode by turning off the printer at any time. Any settings you
have made remain in effect until you change them again.
LQ-690II/LQ-690IIN User’s Guide
Printer Basics 28
To Next Page
Loading...
