Default Policy Setting Items
Items Settings and Explanation
IPsec/IP Filtering You can enable or disable an IPsec/IP Filtering feature.
Access Control Configure a control method for traffic of IP packets.
Permit Access Select this to permit configured IP packets to pass
through.
Refuse Access Select this to refuse configured IP packets to pass
through.
IPsec Select this to permit configured IPsec packets to pass
through.
IKE Version Displays the IKE version.
Authentication Method Displays compatible authentication methods.
Pre-Shared Key Enter a pre-shared key between 1 and 127 characters.
Confirm Pre-Shared Key Enter the key you configured for confirmation.
Encapsulation If you select IPsec for Access Control, you need to configure an encapsulation
mode.
Transport Mode If you only use the printer on the same LAN, select
this. IP packets of layer 4 or later are encrypted.
Tunnel Mode If you use the printer on the Internet-capable network
such as IPsec-VPN, select this option. The header and
data of the IP packets are encrypted.
Remote Gateway(Tunnel Mode) If you select Tunnel Mode for Encapsulation, enter a gateway address between
1 and 39 characters.
Network Guide
Security Settings
39
To Next Page
Loading...
