Epson Perfection 4870 Photo - Removal of TPU Unit Cable

Perfection 4870 Photo Revision A
DISASSEMBLY/ASSEMBLY Disassembly Procedure 62
4.2.19 Removal of TPU Unit Cable
1. Remove the Hinge (Right). (Refer to 4.2.15 Removal of Hinges )
2. Disconnect the TPU Unit Connector from the TPU Main Board.
Figure 4-57. Removal of TPU Unit Cable
Route the TPU Unit Cable by passing it through the notches as shown
in Figure 4-58.
Figure 4-58. Routing of TPU Unit Cable
TPU Unit Connector
Notches