Epson Perfection V500 Photo - Removing the Panel Board

EPSON Perfection V500 Photo Revision A
DISASSEMBLY / ASSEMBLY Disassembly Procedure 35
4.2.4 Removing the Panel Board
1. Remove the Carriage Unit. See Section 4.2.3 on page 33.
2. Pull the ground terminal out of the Carriage shaft hole of the Lower Housing.
3. Lift the Panel Board and disconnect the Panel FFC Connector CN1, then remove
the Panel Board.
Figure 4-11. Removing the Panel Board
Ground Cable
Carriage Shaft
Hole
Notch
Panel Board
Constricted Parts and Tabs
Notch
CN1
When reinstalling the Panel Board, pay attention to the followings.
 Put the shaft spring into the Carriage shaft hole with the convex
surface of the spring faces the shaft side, and then put the
ground terminal into the shaft hole notch.
Figure 4-12. Attaching the Shaft Spring/Ground Terminal
 Route the ground cable through the notches as shown in Figure
4-11.
 Insert the two constricted parts on both left and right ends of
the Panel Board into the tabs of the Lower Housing and match
the three notches of the board with the three tabs of the Lower
Housing as shown in Figure 4-11
.
Carriage Shaft
Hole
Ground Terminal
Shaft Spring