Epson Perfection V500 Photo - Removing the Power Switch

EPSON Perfection V500 Photo Revision A
DISASSEMBLY / ASSEMBLY Disassembly Procedure 38
4.2.6 Removing the Power Switch
1. Move the Carriage Unit to the front of the main unit. See Section 4.2.3 Step 1 -
Step 3
2. Disconnect the Power Switch Connector CN3 from the Main Board. See Section
4.2.5 Step 5 - Step 9
3. Remove the Power Switch Connector Cable from the cable trench.
Figure 4-19. Removing the Power Supply Cable
4. Push the Power Switch toward the outside while releasing the two tabs, and
remove the Power Switch by pushing it out through the hole on the Lower
Housing.
Figure 4-20. Removing the Power Switch
When reinstalling the Power Switch, route the Power Switch
Connector Cable through the cable trench as shown in
Figure
4-19.
Cable Trench
Power Switch Connector Cable
Power Switch
Tabs