Epson Perfection V500 Photo - Removing the Driven Pulley, Driven Pulley Spring, and the Driven Pulley; Holder Assy

EPSON Perfection V500 Photo Revision A
DISASSEMBLY / ASSEMBLY Disassembly Procedure 40
4.2.8 Removing the Driven Pulley, Driven Pulley Spring,
and the Driven Pulley Holder Assy.
1. Remove the Carriage Unit. See Section 4.2.3 on page 33.
2. Hold the A part of the Driven Pulley Holder Assy. and slide it in the direction of
the arrow to remove the assy. from the two tabs on the Lower Housing.
Figure 4-23. Removing the Driven Pulley Holder Assy.
3. Remove the Driven Pulley Spring from the Driven Pulley Holder Assy.
4. Remove the washer and remove the Driven Pulley from the shaft of the Driven
Pulley Holder Assy.
Figure 4-24. Removing the Driven Pulley and the Driven Pulley Spring
Tabs
Driven Pulley Holder Assy.
A part
Washer
Driven Pulley
Driven Pulley Spring