Epson Perfection V500 Photo - Removing TPU Lower Housing

EPSON Perfection V500 Photo Revision A
DISASSEMBLY / ASSEMBLY Disassembly Procedure 43
4.2.10 Removing TPU Lower Housing
1. Remove the TPU Unit. See Section 4.2.1 on page 31.
2. Slide the Housing Mat (Document Cover) to the front of the main unit and remove
it from the four slots of the TPU Unit.
3. Release the TPU Carriage Lock.
Figure 4-28. Removing the Housing Mat (Document Cover)
4. Remove the six C.B.P. M3 x 12 screws and the two C.B.P. M3 x 8 screws that
secure the TPU Lower Housing.
Figure 4-29. Removing the TPU Lower Housing (1)
5. Lift the rear (hinge side) of the TPU Lower Housing and slide it in the direction of
the arrow to release the two tabs and remove the TPU Lower Housing.
Figure 4-30. Removing TPU Lower Housing (2)
Slots
Unlock
Lock
TPU Lower Housing
Housing Mat
Tabs
C.B.P. 3 x 12
(7±1 kgf.cm)
C.B.P. 3 x 8
(7±1 kgf.cm)
Tabs
5-1
5-2