Epson Perfection V500 Photo - Removing the TPU Unit Cable

EPSON Perfection V500 Photo Revision A
DISASSEMBLY / ASSEMBLY Disassembly Procedure 45
4.2.13 Removing the TPU Unit Cable
1. Remove the TPU Lower Housing. See Section 4.2.10 on page 43.
2. Remove the left and right Hinges. See Section 4.2.12 on page 44.
3. Remove the C.B.P. M3 x 8 screw that secures the TPU Unit Cable.
4. Disconnect the TPU Unit Connector CN1 from the DRV Board.
5. Release the TPU Unit Cable from the notches shown in the figure below.
Figure 4-33. Removing the TPU Unit Cable
Notches
Cable Tie
DRV Board
CN1
TPU Unit Cable
C.B.P. 3 x 8
(4.5±0.5kgf.cm)
 When installing the TPU Unit Cable, put the cable and the
cable tie into the notches as shown in Figure 4-33
.
 When connecting the TPU Unit Cable to the DRV Board, route
the cable as shown in the figure below.
Figure 4-34. Routing the TPU Unit Cable
DRV Board
TPU Unit Cable
Ground