Epson Perfection V500 Photo - Removing the TPU CR Motor

EPSON Perfection V500 Photo Revision A
DISASSEMBLY / ASSEMBLY Disassembly Procedure 50
4.2.17 Removing the TPU CR Motor
1. Remove the Hinge Assy.s. See Section 4.2.12 on page 44.
2. Remove the TPU Carriage Unit. See Section 4.2.15 on page 46.
3. Disconnect the TPU CR Motor Connector CN2 from the DRV Board.
4. Remove the acetate tape and release the CN2 Connector Cable from the notch and
tabs shown in
Figure 4-46.
Figure 4-46. Removing the TPU CR Motor Connector
5. Remove the three C.P.F.P. M3 x 8 screws that secure the TPU CR Motor Unit and
remove it.
Figure 4-47. Removing the TPU CR Motor Unit (1)
6. Remove the TPU CR Timing Belt from the TPU Driven Pulley and remove the
TPU CR Motor Unit.
Figure 4-48. Removing the TPU CR Motor Unit (2)
C A U T I O N
When performing the procedure given below, be careful not to lose
the three torsion springs that apply tension to the TPU CR Timing
Belt.
Notch
CN2
TPU CR Motor Unit
DRV Board
Tabs
Acetate Tape
C.P.F.P. 3 x 8
(4.5±0.5kgf.cm)
TPU CR Timing
TPU Driven Pulley