Epson PERFECTION V700 PHOTO - Selecting an Epson Scan Mode

EPSON Perfection V700 Photo Revision A
Disassembly / Assembly Disassembly Procedure 44
4.2.4 Removing the Panel Board
1. Disconnect the Panel Board Connector CN1 from the Sub Board.
See Step 1 to Step 3 in Section 4.2.3
2. Remove the C.B.P. M3 x 8 screw that secure the Front Cover, and
remove it.
Figure 4-15. Removing the Front Cover
3. Remove the C.B.P. M3 x 8 screw that secure the Panel Board and
remove the board releasing it from the hooked tab.
Figure 4-16. Removing the Panel Board
C.B.P. M3x8 (7±1 kgf.cm)
Inside of the scanner
Front Cover
 If the LED Cover accidentally becomes detached,
install it matching the positioning holes and guide pins
as shown below.
Figure 4-17. Installing the LED Cover
 When installing the Panel Board, match the positioning
holes and the guide pins as shown in Figure 4-16.
C.B.P. M3x8 (7±1 kgf.cm)
Panel Board
Tab
Positioning Holes and Dowels
Positioning Holes and Dowels
LED Cover