61
If there are gaps, press Clean to clean the print head again. You may need to clean
it two or three times before the nozzles are clean.
If you don’t see any improvement after cleaning three times, refer to Solving
Problems.
You can also turn PictureMate Pal off and wait overnight to allow any dried ink to
soften. Then try cleaning the print head again.
Aligning the Print Head Using the Computer
If you have moved PictureMate Pal and the print quality is not as good as it used to
be—if your prints look fuzzy or have light or dark lines running through them—you
may need to align the print head.
1. Make sure PictureMate Pal is connected to your computer and turned on but not
printing.
2. Load paper in PictureMate Pal so you can print the head alignment pattern. See
Loading Paper for details.
3. Windows: Right-click the printer icon on your taskbar (in the lower right
corner of your screen). Select Print Head Alignment.
Macintosh: Open the Applications folder and select EPSON Printer Utility.
Select PictureMate PM 200 in the printer list, click OK, and select Print Head
Alignment.
4. Follow the instructions on the screen to print the alignment pattern:
Best pattern
Misaligned pattern
To Next Page
Loading...
